The easy to use, safe, high performance spray on waterproofing for wet weather clothing. Adds Durable Water Repellency, revives breathability and maintains internal wicking properties. Breathable waterproof garments are most likely to get sweaty and wet inside when used in damp or wet conditions. If the outer fabric absorbs water, the garment can lose up to 70% of its breathability. Therefore, the Durable Water Repellency (DWR) on the outer fabric of your jacket must be maintained to ensure comfort. It will eventually wear off and need to be renewed with Nikwax TX.Direct®. Your raingear could be soaking up water just because it is dirty. First, try cleaning it with Nikwax Tech Wash®, and if it is fairly new, or recently re-waterproofed, the Durable Water Repellency (DWR) will be revitalised just from cleaning.  But, once the garment has been thoroughly worn, you will need to add DWR, using Nikwax TX.Direct®, after cleaning first with Nikwax Tech Wash®. For best results remove all non-washable parts and always clean item(s) first with Nikwax Tech Wash®. No need to dry item(s) before waterproofing. Protect working surface and lay clean wet fastened garment flat. Hold bottle 15 cm/6 inches away from garment. Apply evenly to outside of fabric. Wait for 2 minutes. Remove any surplus product with a damp cloth. Check carefully to ensure no areas have been missed. After several minutes check for and remove any surplus product with a damp cloth.