Made by Kopper Kreations .  Made in Dublin.   DescriptionWith its elegant and modern form this copper floor lamp is sure to add a nice accent to any space. The clever design incorporates a dimmer switch which unlocks the true potential of the exposed Edison bulb . It can be dimmed from a low to high setting with ease which gives the lamp real functionality meaning it can be used in a multitude of settings. It also has a floor switch so once the required setting is achieved it can be turned on and off with the floor switch. Its a delicate lamp and very much a design piece so maybe not suited to busy environments with a lot of traffic. A clever reuse of old gas copper pipe. This beautiful copper pipe lamp has been bent by hand from one 3m piece of recycled plumbing pipe. The copper is hand polished to a natural finish that will age and develop character over time.   This lamp was designed around the exposed Edison bulb and the design was developed to accentuate their beauty. This floor lamp will not only lighten up your space with a delicate and ambient tone but will also add a quirky and artistic note. Specification10mm reclaimed copper pipe. As it is handmade the dimensions may vary slightly but never more than a few mm!  Measurements:350mm wide1500mm high350mm deep Electrical:All components are CE certified0.75mm2 black twisted braided 3 core cableInline dimmer switch 220-240VCopper effect lamp holder c/w cord grip125mm E27 Vintage Edison BulbUK 3 pin plug c/w 3 amp fuseInline on/off floor switchFully earthed and electrically tested Care InstructionsAll materials used are recycled or salvaged where possible. No lacquer or covering is used. The material is polished to a natural finish by hand and the products are designed to age over time. Over time copper naturally changes colour. Transforming from a shiney brown/red colour to darker browns, then blues and finally greens after a number of years. When exposed to the natural elements copper develops this ‘patina’ which actually protects and preserves the metal underneath. If you wish to clean the copper, we recommend some very fine wire wool or some P1000 or higher silicone carbide sandpaper both of which can be picked up from your local hardware shop. Please make sure the lamp is disconnected from the mains before cleaning. Please do not clean the copper effect lamp holder as its painted!